|
Education
B.S. 1975, Metallurgical Engineering, Michigan Technological University
M.S. 1977, Ph.D. 1982, Metallurgical Engineering, University of Wisconsin-Madison
Ph.D., University of Wisconsin-Madison
Academic Experience
- Staff Metallurgist, U.S. Naval Research Laboratory, 1982-1987
- Ames Laboratory, 1987-present; Editorial Review Committee International Journal of Powder Metallurgy
- Fellow of ASM International
- Chairman of Materials Processing and Manufacturing Division of TMS
Research Interests
- Powder metallurgy
- Rapid solidification
- High-pressure gas atomization
- Centrifugal atomization
- Powder processing of magnetics
- Electronic and Stuctural Materials
- Joining Materials Design
Grants and Contracts
- Anderson, I. E., Department of Commerce/ITA, 07/01/93-12/31/98, "Development of an In-Situ Control System for a High Pressure Gas Atomization Nozzle."
The objective of this program is to develop an active, in-situ control system for the primary operating parameters of a high pressure gas atomization nozzle to provide improved steady-state operation of close-coupled atomization nozzles and enhanced size control in the manufacture of metal powders. (Administered by Institute for Physical Research and Technology/Center for Advanced Technology Development)
- Anderson, I. E., 10/01/96-09/30/99, "Development of Low-Cost Powder Metallurgy Technology for Particle Reinforced Aluminum Composites."
Development of a greatly simplified processing approach for particulate reinforced Al composites is being pursued to enable automotive and other mass production applications for such strong, light-weight, structural materials. Emphasis is placed on both alloy design and process research, especially for generation of Al powders by a gas atomization reaction synthesis process. (Administered by Ames Laboratory)
Publications
- I. E. Anderson, V. K. Pecharsky, J. Ting, C. Witham, R. C. Bowman
"Benefits of rapid solidification processing of modified LaNi5 alloys by high pressure gas atomization for battery applications," Mat. Res. Soc. Symp. Proc., 496, 37 (1998).
-
J. F. Flumerfelt, I. E. Anderson, J. C. Foley
"Consolidation of pure aluminum powders," in Advances in Powder Metallurgy and Particulate Materials-1977, Part 10, edited by R. A. McKotch and R. Webb (MPIF-APMI, Princeton, NJ, 1997), p. 11.
-
J. Ting, J. Mi, I. E. Anderson, R. L. Terpstra
"Optimizing melt tip geometry for high pressure gas atomization," in Advances in Powder Metallurgy and Particulate Materials-1997, Part 5, edited by R. A. McKotch and R. Webb (MPIF-APMI, Princeton, NJ, 1997), p. 53.
-
P. D. Prichard, I. E. Anderson, J. Kameda
"The structure-property relationship of powder processed Fe-Al-Si alloys," in Advances in Powder Metallurgy and Particulate Materials-1997, Part 13, edited by R. A. McKotch and R. Webb (MPIF-APMI, Princeton, NJ, 1997), p. 103.
|
|
